Feman Tooling Co.,Limited
Feman Tooling Co.,Limited
Contact Us

The Effect of High Temperature in Injection Molding Process on Injection Molded Parts

Table of Content [Hide]

    Ⅰ. The impact of temperature on injection molded parts during the injection molding process


    Manufacturers of injection molded parts know that during the plastic injection molding process, if the temperature is too high or too low, it will have an adverse effect on the molded injection parts. Seriously, it may directly cause the molded injection parts to be scrapped. Therefore, the temperature control in the injection molding process is very important. 


    So what effect will the high temperature in the injection molding process have on the injection molded parts? Let Feman injection manufacturing give you some examples.



    Ⅱ. The impact of high temperature in injection molding processing on injection molded parts


    1. Too high temperature will reduce the viscosity of the oil


    When the temperature of injection molding is too high, the viscosity of the oil will decrease, and leakage may occur. At this time, the volumetric efficiency of the pump and the efficiency of the entire system will also be significantly reduced. If the viscosity of the oil decreases, the oil film of the moving parts such as the slide valve will become thin or will be cut. At this time, the frictional resistance will also increase, which will increase the phenomenon of wear.


    2. Accelerate the deterioration of oil due to oxidation


    Process of high temperature injection molding will accelerate the oxidation and deterioration of the oil, resolve the bituminous substance, and reduce the service life of the hydraulic oil. The resolved substance will block the damping orifice and the gap-type valve port, which will cause the pressure valve to become stuck and not work. The metal pipe stretches and bends, and even breaks.


    3. Cause the work quality of injection molded parts to deteriorate


    Excessive heating process of the custom plastic injection molding will result in poor working quality of the injection molded parts, and the dissolved air in the oil will escape and air pockets will appear, which will reduce the working performance of the hydraulic system.


    4. The phenomenon that causes thermal deformation of the machine


    In the hydraulic components, the fitting clearance of parts with different thermal expansion coefficients becomes smaller and jams, which will cause work failure, seriously affect the transmission accuracy of the hydraulic system, and cause the work quality of injection molded parts to deteriorate.

    References
    • The Causes of Short Injection Products

      The main reason for the dissatisfaction of injection molding products is the lack of material and the mismatch of injection pressure and speed (including excessive pressure loss caused by resistance)....
    • Considerations in ABS Plastic Injection Molding Process

      ABS (Acrylonitrile Butadiene Styrene) plastic injection molding is a widely used manufacturing process for creating various components and products. To achieve successful results and ensure the produc...
    • Main Equipment for Injection Molding

      Plastics commonly used for injection molding are classified as thermoplastics and thermosetting plastics. Injection moulding machines use these two plastics to make all kinds of needed plastic product...